ISOLED RGB LED Strip 5m, 60 LED/m, 12V, 8W/m, WS2815
€86.90
Available, delivery time: 1-3 days
Product information "ISOLED RGB LED Strip 5m, 60 LED/m, 12V, 8W/m, WS2815"
RGB LED Strip 5m / 60 LEDs/m / 12V / WS2815
Addressable RGB flex strip with WS2815 chip, 12V design and 60 individually controllable LEDs per meter – reliable, WLED-compatible and available in two protection ratings.
60 LEDs/m, 1 LED per zone
With 60 individually addressable LEDs per meter and a cut point every 16.67 mm, the strip is ideal for uniform effect lighting where every light point is controlled independently.
12V – practical operating voltage
Compared to 5V strips, the 12V design allows longer cable runs without noticeable voltage drop – ideal for installations where the controller is not located directly at the strip.
Variants
| IP20 | IP68 | |
|---|---|---|
| Protection rating | IP20 – for indoor use | IP68 – fully waterproof (silicone potting) |
| Width | 10 mm | 12 mm |
| Height | 2 mm | 5 mm |
| Ambient temperature | 0°C – 40°C | −20°C – 40°C |
| Cooling | Heatsink required (min. 45 g/m) | No heatsink required |
| Connectors | C1-410 / C2-410 | O1-412 |
| Included | Strip + 3M adhesive tape | Strip + 3M adhesive tape + 4 end caps + 20 mounting clips + 40 screws |
Specifications
- 60 LEDs/m, RGB, 1 LED per IC
- WS2815 chip, 12V DC, 8W/m
- 300 LEDs on 5m
- Cut point every 16.67 mm (1 SMD each)
- Beam angle 120°
- Max. length per power injection: 5m
- Dimmable via PWM
- Connection cable on both ends
- Adhesive tape: 3M 300LSE
- Rated lifetime: 57,000 h (L70|B50)
- Warranty: 2 years
WLED Configuration
The strip is fully WLED-compatible and is configured as follows:
- LED type: WS2812B / WS2815
- Number of LEDs: 300 (for 5m)
We recommend using our cod.m WLED Controller.
Ideal for
- Room lighting and ambient light
- TV and media walls
- Indirect ceiling and profile lighting (IP20)
- Outdoor installations, wet areas, bathrooms (IP68)
- Smart Home / Home Assistant / WLED setups
Usage Notes
- IP20: A heatsink profile of at least 45 g/m is mandatory – without adequate cooling, the strip's lifespan will be significantly reduced
- IP68: Any cuts must be resealed with sealant adhesive and end caps to maintain the protection rating
- Only cut at the copper pads – cutting elsewhere may damage traces
- Clean and degrease the surface before applying – once stuck down, do not remove
